New PZ Owner affectionately named "Rusty"
-
- Former Member
- Posts: 8
- Joined: Mon Feb 17, 2020 11:10 pm
- RX-8: PZ
- Colour: Galaxy Grey
- Location: Stafford
- Has thanked: 4 times
- Been thanked: 0
New PZ Owner affectionately named "Rusty"
Just wanted to say hello new to the club and car based in Midlands.
-
- Forum Moderator
- Posts: 12433
- Joined: Mon Jun 28, 2004 11:38 pm
- RX-8: 40th Anniversary
- Colour: Crystal White
- Location: In the land of the big cat!
- Has thanked: 42 times
- Been thanked: 229 times
Re: New PZ Owner affectionately named "Rusty"
Have a good read up of the various sections you will learn a lot, where in the Midlands are you based?
*
*
Del.
1st Brilliant Black 190. 2nd Brilliant Black PZ. 3rd Strato Blue 230. 4th Crystal White 40th Anniversary.
Rotary FX fender grills, Japspeed stainless exhaust, Cosworth Air filter, Kinetix slotted & dimpled discs, EBC Red stuff pads, Ryan Rotary MK11 coils, Magnecor leads, Stainless front & rear grills, HID main beams, LED tail lights, front side lights/front fogs.
Rotary FX fender grills, Japspeed stainless exhaust, Cosworth Air filter, Kinetix slotted & dimpled discs, EBC Red stuff pads, Ryan Rotary MK11 coils, Magnecor leads, Stainless front & rear grills, HID main beams, LED tail lights, front side lights/front fogs.
-
- Former Member
- Posts: 64953
- Joined: Sun Dec 10, 2006 6:57 pm
- Location: Somewhere in the UK
- Has thanked: 1581 times
- Been thanked: 365 times
New PZ Owner affectionately named "Rusty"
Hi & to the RX-8OC
<<<<<< Please put your Location in your Profile Box, it will help us to know where you are, if required any help in the future
Please check out the EVENTS SECTION's for anything coming up soon in your area
Events Team
<<<<<< Please put your Location in your Profile Box, it will help us to know where you are, if required any help in the future
Please check out the EVENTS SECTION's for anything coming up soon in your area
Events Team
- These users thanked the author GreySilver Beast for the post:
- b7owa (Fri Feb 21, 2020 7:45 pm)
GreySilver Beast-Test Drives Unlimited (Nigel)
Club Member from 2006 - present
Events Team from 2015 - 2024
Events Coordinator from 2017 - 2023
Administrator from 2012 - present RX-8 Owners Club UK
Tesla M3LR AB 363 AWD " Blue Beast "
Club Member from 2006 - present
Events Team from 2015 - 2024
Events Coordinator from 2017 - 2023
Administrator from 2012 - present RX-8 Owners Club UK
Tesla M3LR AB 363 AWD " Blue Beast "
-
- Club Member
- Posts: 2505
- Joined: Thu Mar 06, 2008 12:29 am
- RX-8: 231
- Colour: Sunlight Silver
- Location: Coventry
- Has thanked: 173 times
- Been thanked: 523 times
Re: New PZ Owner affectionately named "Rusty"
Might want to consider the midlands meets at the Appleby inn, first Thursday of the month.
Led side lights, purple Led interior & puddle lights, pz grills, Ryan rotary performance coils, sump, engine mounts & sohn, HME engine rebuild at 50k, RRP exhaust & high flow cat, racing beat revi intake including scoop, quick shifter, alloy filler cap, pz alloys, suspension, mazdaspeed spoiler, japspeed toe arms & hardrace camber arms, RRP custom remap
-
- Forum Moderator
- Posts: 32772
- Joined: Tue Sep 12, 2006 1:54 am
- RX-8: 192
- Colour: Sunlight Silver
- Location: Kent (out in the sticks - nothing urban here)
- Has thanked: 266 times
- Been thanked: 320 times
Re: New PZ Owner affectionately named "Rusty"
Hi and b7owa. Have a good read through whatever in the FAQ section you didn't already read and then (and just ignore me if you know all this already) here are my best tips for keeping it all running sweetly:
1. To start up turn the key to position 2, wait for most of the lights on the dash to go out (I watch the airbag light by the glove box), press the clutch to the floor (optional, but reduces drag), turn the key to start and do not touch the throttle until it has started. You can drive off straight away, just keep the revs down for a bit (see #4 below).
2. Never turn off the engine before it has reached at least somewhere towards normal operating temperature (should only take a minute or two, but best to go for a short drive if just swapping cars round on the drive etc). Switching off cold risks flooding, which is a real with a rotary engine. Mazda recommend rev to 4k and hold it for 8-10 seconds switching off while still revving if you have no option but to switch off cold (it is not necessary to do this in any other circumstance).
3. Check the oil level regularly (use the dipstick - the oil gauge tells you nothing other than that you have or don't have pressure) and top up if necessary with semi synthetic 5w30 (most people and specialists are advising to use 10w40 now though) ... small amounts at a time, no more than ½ a litre then check the level again before adding more as you don't want to overfill it.
4. Use all the revs once the engine is nice and warm (don't sit idling to warm up, start up and drive but keep it below about 4k until the needle on the water temperature gauge is pointing straight up, then give it another 10 minutes for the oil to warm up too before really thrashing it ) and hit the beep often. Best acceleration is from 4k revs up - to pull away you really need to rev to 2k - you can let the revs drop after lifting the clutch if you are in traffic, cruising steadily at 3½k revs and changing down to go up hills or accelerate gets you the best mpg ... which still won't be great.
5. Join the club for discounts on all sorts of things (you will very quickly get the cost of membership back - and then some), loads more info in the members only sections (including access to all the workshop and technical manuals), local meets (if you can't find one exactly local it is a good excuse for a drive if you come to one a bit further away), a sexy keyring just for joining and more.
1. To start up turn the key to position 2, wait for most of the lights on the dash to go out (I watch the airbag light by the glove box), press the clutch to the floor (optional, but reduces drag), turn the key to start and do not touch the throttle until it has started. You can drive off straight away, just keep the revs down for a bit (see #4 below).
2. Never turn off the engine before it has reached at least somewhere towards normal operating temperature (should only take a minute or two, but best to go for a short drive if just swapping cars round on the drive etc). Switching off cold risks flooding, which is a real with a rotary engine. Mazda recommend rev to 4k and hold it for 8-10 seconds switching off while still revving if you have no option but to switch off cold (it is not necessary to do this in any other circumstance).
3. Check the oil level regularly (use the dipstick - the oil gauge tells you nothing other than that you have or don't have pressure) and top up if necessary with semi synthetic 5w30 (most people and specialists are advising to use 10w40 now though) ... small amounts at a time, no more than ½ a litre then check the level again before adding more as you don't want to overfill it.
4. Use all the revs once the engine is nice and warm (don't sit idling to warm up, start up and drive but keep it below about 4k until the needle on the water temperature gauge is pointing straight up, then give it another 10 minutes for the oil to warm up too before really thrashing it ) and hit the beep often. Best acceleration is from 4k revs up - to pull away you really need to rev to 2k - you can let the revs drop after lifting the clutch if you are in traffic, cruising steadily at 3½k revs and changing down to go up hills or accelerate gets you the best mpg ... which still won't be great.
5. Join the club for discounts on all sorts of things (you will very quickly get the cost of membership back - and then some), loads more info in the members only sections (including access to all the workshop and technical manuals), local meets (if you can't find one exactly local it is a good excuse for a drive if you come to one a bit further away), a sexy keyring just for joining and more.
'Grington.
former Club Treasurer 2010-18 (now finally retired)
Silver 192 green interior LEDS, Nordic Green hoop spoiler, roof inserts and wheels Silver Stripes (now finally retired)
former Club Treasurer 2010-18 (now finally retired)
Silver 192 green interior LEDS, Nordic Green hoop spoiler, roof inserts and wheels Silver Stripes (now finally retired)
-
- Former Member
- Posts: 10000
- Joined: Wed Apr 09, 2014 8:48 pm
- Location: Fantasy land
- Has thanked: 93 times
- Been thanked: 165 times
Re: New PZ Owner affectionately named "Rusty"
Welcome aboard, we all love a good PZ and a not so good one as well.
“Extraordinary claims require extraordinary evidence " Carl Sagan.
-
- Former Member
- Posts: 265
- Joined: Sun Oct 28, 2018 7:21 pm
- RX-8: PZ
- Colour: Galaxy Grey
- Location: West Sussex
- Has thanked: 32 times
- Been thanked: 35 times
Re: New PZ Owner affectionately named "Rusty"
Welcome fellow PZ owner, post pics when you get chance.
Galaxy Grey PZ number 24.
Large street port. Lots of flames, lots of smiles.
Large street port. Lots of flames, lots of smiles.
-
- Media Team
- Posts: 1729
- Joined: Mon Mar 11, 2019 10:52 pm
- RX-8: PZ
- Colour: Brilliant Black
- Location: Salisbury, Wiltshire
- Has thanked: 121 times
- Been thanked: 202 times
Re: New PZ Owner affectionately named "Rusty"
Welcome! I decided not to tempt fate calling mine that, despite how appropriate it may be...
- These users thanked the author Honkytonk for the post:
- 30405 (Tue Feb 18, 2020 12:48 pm)
Want to Take Part in the Club YouTube channel? Click Here!
Marvel at the Amazing Technicolour P-Shed Project Thread
And my OEM-only Luton Adonis, the Mighty Vectra!
Marvel at the Amazing Technicolour P-Shed Project Thread
And my OEM-only Luton Adonis, the Mighty Vectra!
-
- Committee Member
- Posts: 5313
- Joined: Sat Apr 13, 2019 6:40 pm
- RX-8: 231
- Colour: Custom
- Location: Cider Country
- Has thanked: 11 times
- Been thanked: 283 times
Re: New PZ Owner affectionately named "Rusty"
Ive seen shipwrecks with less rust.
- These users thanked the author Ollie for the post (total 2):
- 30405 (Tue Feb 18, 2020 4:07 pm) • b7owa (Fri Feb 21, 2020 7:50 pm)
Club Treasurer
Kentaro The Red - Sadly fallen...
Star Platinum - Work in progress
For whats pending... See here: viewtopic.php?f=204&t=86071
Kentaro The Red - Sadly fallen...
Star Platinum - Work in progress
For whats pending... See here: viewtopic.php?f=204&t=86071
-
- Former Member
- Posts: 8
- Joined: Mon Feb 17, 2020 11:10 pm
- RX-8: PZ
- Colour: Galaxy Grey
- Location: Stafford
- Has thanked: 4 times
- Been thanked: 0
-
- Former Member
- Posts: 8
- Joined: Mon Feb 17, 2020 11:10 pm
- RX-8: PZ
- Colour: Galaxy Grey
- Location: Stafford
- Has thanked: 4 times
- Been thanked: 0
Re: New PZ Owner affectionately named "Rusty"
Not too good with the old URL Image thing but attempted above.
-
- Former Member
- Posts: 8
- Joined: Mon Feb 17, 2020 11:10 pm
- RX-8: PZ
- Colour: Galaxy Grey
- Location: Stafford
- Has thanked: 4 times
- Been thanked: 0
Re: New PZ Owner affectionately named "Rusty"
<a href="https://ibb.co/dKQgMLW"><img src="https://i.ibb.co/VBvm9Qj/Side.jpg" alt="Side" border="0"></a>
-
- Forum Moderator
- Posts: 9153
- Joined: Fri Aug 04, 2017 4:56 pm
- RX-8: Turbo
- Colour: Nordic Green
- Location: cornwall
- Has thanked: 100 times
- Been thanked: 544 times
Re: New PZ Owner affectionately named "Rusty"
pics hotlinked for you.
- These users thanked the author qwakers for the post (total 2):
- warpc0il (Fri Feb 21, 2020 8:16 pm) • b7owa (Fri Feb 21, 2020 8:30 pm)
-
- Former Member
- Posts: 265
- Joined: Sun Oct 28, 2018 7:21 pm
- RX-8: PZ
- Colour: Galaxy Grey
- Location: West Sussex
- Has thanked: 32 times
- Been thanked: 35 times
Re: New PZ Owner affectionately named "Rusty"
Looks lovely, same colour as mine.
You do not have the required permissions to view the files attached to this post.
- These users thanked the author Scotty PZ for the post:
- b7owa (Sat Feb 22, 2020 7:05 pm)
Galaxy Grey PZ number 24.
Large street port. Lots of flames, lots of smiles.
Large street port. Lots of flames, lots of smiles.